Asko TDC44 - Fuse; Changing the Fuse; Changing the Fuse Holder;Insert

42
SERVICE
2
3
2
3
4
FUSE
Changing the fuse
1. Remove the fuse holder insert with a screw-
driver (1/4 turn).
2. Change the fuse.
IMPORTANT
The fuse must be of 250V and 6.3 Ampere type.
3. Fit the fuse holder insert with the fuse into
the fuse holder.
Changing the fuse holder/insert
1. Remove the three screws at the rear edge and
lift off the top cover.
2. Remove the wiring that goes to the fuse hol-
der.
3. Remove the fuse holder insert with a screw-
driver (1/4 turn).
4. Unscrew the fuse holder.
5. Fit the new fuse holder.
6. Connect the wiring.
7. Install the fuse holder and its insert.
8. Fit the top cover.