Asko TDC44 - SPECIFICATIONS; Key Technical Specifications

86 pages

Save Page as PDF

To Next Page

To Previous Page

SPECIFICATIONS

PRINCIPAL DIMENSIONS

Height: 850 mm

Width: 595 mm

Depth: 585 mm

Weight:

TDC33 39 kg

TDC44 47 kg

VOLUME/CAPACITY

Drum volume: 111 litres

Drying capacity : 5.0 kg

Speed: 52 rpm

ELECTRICAL CONNECTION ALTERNATIVES

Power consumption: See type label

Heating element power: See type label

Drying drum material:

Stainless steel.

Outer casing material:

Powder-painted and hot galvanised steel plate

or stainless steel.

Installation:

Tower, free-standing or built-in.

Drain

TDC44: 2.0 m rubber hose

Air extraction hose

TDC33: 3.0 m PVC

SPECIFICATIONS

Main Page

Default Chapter4
- Table of Contents4
Safety Regulations7
Specifications8
The Drying Process9
- Tdc339
- Tdc4410
Installation11
- Tumble Drier Location11
- Location Alternatives11
- Adjusting the Feet13
- Condensation Water (TDC44)13
- Air Extraction (TDC33)14
- Electrical Installation16
Doorhanging17
- Left Hanging to Right Hanging17
- Right Hanging to Left Hanging19
Fault Tracing21
Problems23
Components and Measurements24
Test Program and Fault Indications28
- Test Program28
- Internal Counter28
- Fault Indications28
Consumption Values29
- Tdc3329
- Tdc4430
Tools31
- List of Tools31
- Application Areas32
Special Tools34
Service35
- Top Cover35
- Removing the Top Cover35
- Installing the Top Cover35
- Changing the Guides35
- Removing the Rear Panel36
- Installing the Rear Panel36
- Removing the Inner and Outer Rear Panels37
- Installing the Inner and Outer Rear Panels37
- Changing the Foam Rubber Seal38
- Changing the Bearing38
- Changing the Rear Felt Strip Seal39
- Changing/Cleaning the Heating Element39
- Changing the Overheating Protection Device40
Input Terminal Block41
- Removing the Input Terminal Block41
- Installing the Input Terminal Block41
- Removing the Radio Interference Filter42
- Installing the Radio Interference Filter42
Contactor43
- Removing the Contactor43
- Installing the Contactor43
Fuse44
- Changing the Fuse44
- Changing the Fuse Holder/Insert44
Drum45
- Removing the Drum45
- Installing the Drum45
- Changing the Drive Belt45
- Changing the Drum Ridge46
External Fan Housing (TDC44)47
- Removing the External Fan Housing47
- Installing the External Fan Housing47
- Cleaning the External Fan Wheel47
Motor48
- Removing the Motor48
- Installing the Motor48
- Changing the Capacitor49
Air Extraction System50
- Removing the Exhaust Air Duct Hook50
- Installing Exhaust Air Duct Hook50
- Removing the Exhaust Air Duct T-Piece50
- Installing the Exhaust Air Duct T-Piece50
Humidity Sensor51
- Removing the Humidity Sensor51
- Installing Humidity Sensor51
Thermistor52
- Removing the Thermistor52
- Installing the Thermistor52
Front Frame53
- Removing the Front Frame53
- Installing the Front Frame53
- Changing the Front Felt Seal54
- Changing the Support Roller54
Front Door55
- Removing the Front Door55
- Installing the Front Door55
- Changing the Hinge Pin55
- Changing the Hinge Socket56
- Changing the Door Magnet/Escutcheon Plate56
- Changing the Handle56
- Changing the Inner Door57
- Changing the Outer Door Seal57
- Changing the Inner Door Seal57
- Changing/Cleaning the Filter Holder58
- Changing the Door Switch58
- Changing the Door Switch Pin59
Front Panel60
- Removing Front Panel60
- Installing Front Panel60
- Changing the Fixing Clip for the Bottom Cover (Female)61
- Changing the Fixing Clip for the Bottom Cover (Male)61
Panel62
- Removing the Panel62
- Installing the Panel62
- Changing the Panel Handle63
- Changing the Indication Lamp/Symbol Lens63
- Changing the Main Power Button64
- Changing the Push-Button Switches65
- Changing the DCU Panel Board and the Push-Buttons65
Electronic Control Unit66
- Changing the Electronic Control Unit66
- Installing Electronic Control Unit with Its Holder67
Condenser Housing (TDC44)68
- Removing the Condenser Housing68
- Installing the Condenser Housing68
- Changing the Condensed Water Pump68
- Changing the Microswitch for the Condensed Water Pump69
- Changing the Foam Rubber Seal69
- Changing the Float70
- Water Tank Housing (TDC44)71
- Side Panels72
  - Changing the Side Panels72
- Bottom73
  - Changing the Bottom73
- Front Rail73
  - Changing the Front Rail73
Program and Options74
- Programs74
- Drying Time74
Change Settings75
- Language75
- Locking a Programme75
- Child Lock on Button75
Program Overview77
Tumble Drying77
Cleaning and Maintenance78
- Cleaning the Fluff Filter78
- Emptying the Condensed Water Tank (TDC44)78
- Cleaning the Outside of the Machine79
- Cleaning the Fan79
- Cleaning the Condenser (TDC44)80
  - Drying Guide82
Drying Guide TDC4484
Drying Guide TDC3384
Circuit Diagram84

Related product manuals

Asko TDC44 - SPECIFICATIONS; Key Technical Specifications

Table of Contents

Related product manuals