Asko TDC44 - Changing the Fixing Clip for the Bottom Cover (Female); Changing the Fixing Clip for the Bottom Cover (Male)

59
SERVICE
Changing the fixing clip for the bottom cover
(female)
1. Remove the bottom cover.
2. Squeeze the snap fasteners and pull or push
out the clip.
3. Install a new clip.
4. Install the bottom cover.
Changing the fixing clip for the bottom cover
(male)
TDC33, Left TDC44:
1. Remove the bottom cover.
2. Squeeze the snap fasteners and pull or push
out the clip.
3. Install a new clip.
4. Install the bottom cover.
Right TDC44:
1. Remove the bottom cover.
2. Remove the condenser housing in accordance
with the section "Condenser housing - remo-
ving...".
3. Squeeze and pull or push out the clip.
4. Install a new clip.
5. Install the condenser housing in accordance
with the section "Condenser housing - instal-
lation...".
6. Install the bottom cover.
IMPORTANT!
Late change:
The design of the bottom cover has been changed on
machines manufactured week 46/2000 or later.
Also see service information Group 22 No.47.