Need help?Do you have a question about the ASL INTERCOM LP01 and is the answer not in the manual?
General| Brand | ASL INTERCOM |
|---|---|
| Model | LP01 |
| Category | Switch |
| Language | English |
Details the physical port specifications of the NETWORK-SWITCH-LP01, including RJ45 and SFP ports.
Lists the necessary PC hardware and software requirements for configuring the network switch.
Explains compatibility and network traffic considerations for systems with VIPEDIA-12-PRO or INTEGRA-PRO units.
Details the physical connections for power and fault relay, emphasizing safety compliance.
Specifies the default IP address and netmask, warning against connecting switches before configuration.
Guides on connecting the fault relay to the PAVA system and configuring it for fault reporting.
Explains how to configure DIP switches for monitoring Ethernet connections and power supply for fault reporting.
Details how to configure DIP switches to match the connection speed of SFPs in ports 9 and 10.
Guides on logging into the switch and configuring its IP address, subnet mask, and hostname.
Details the configuration steps for enabling and setting up the ASL Secure Loop (RSTP) for network redundancy.
Explains the importance of QoS for Dante audio and provides steps to configure DSCP values for optimal performance.
Guides on enabling IGMP snooping, crucial for IP microphones and multicast traffic, with specific settings.
Instructs on using Dante Controller to set audio latency to 5 ms to prevent dropouts and errors.
Covers saving the switch configuration to the device or PC, and loading configurations from a PC.
Provides detailed steps on how to configure the PC's IP address for network communication with the switch.
Explains how to verify network connectivity to the target unit using the 'ping' command.
Outlines the procedure for restoring the network switch to its original factory default settings.
To Next Page