NETWORK-SWITCH-LP01 – Configuration Guide
U-0641-3675.docx – Issue: 01 complete, approved
Page 7 of 28
3 Configuration
3.1 Login
To log in to NETWORK-SWITCH-LP01:
1. Power on and connect the configuration PC to the network switch.
2. Launch a web browser and enter the IP address of the network switch.
3. Enter the username and password, then click “Login”.
Default username and password:
• “User Name”: admin.
• “Password”: admin.
If the network switch has previously been configured, it is recommended to perform a factory reset
before continuing. If required, refer to section 5 APPENDIX – Factory Reset on page 26.
Do not connect network switches together until the configuration in the following sections is
complete for each unit.
This is to prevent configuration issues due to multiple network switches with the same IP address,
and to prevent data storm due to RSTP being disabled by default.
The default IP address for NETWORK-SWITCH-LP01 units is 192.168.2.5 and the netmask is
255.255.255.0.
For instructions on how to change the User Name and Password refer to the NETWORK-
SWITCH-LP01 User Manual.
To Next Page
Loading...
Need help?
General