NETWORK-SWITCH-LP01 – Configuration Guide
U-0641-3675.docx – Issue: 01 complete, approved
Page 9 of 28
5. To reconnect to the network switch:
a. Configure the PC network interface as required to communicate with the new IP settings on
the network switch. For instructions, refer to section 4 APPENDIX – PC Requirements on
page 23.
b. Enter the network switch IP address.
6. Log in to the device.
7. Click the save icon in the top right corner of the configuration window.
The IP and name settings are now saved onto the device and may be powered off if required.
To Next Page
Loading...