Astoria Plus4YouTS SAEP - Energy Saving Management; Programmed Energy Saving Mode; Dispensing Group Standby Mode

Plus4YouTS
User Manual
52 of 216
6.11 Energy Saving Management
6.11.1 Programmed energy saving mode
When programmed, it automatically puts one or more groups
into standby mode when the workload decreases and pre-
pares them for full capacity when needed.
The following icon indicates the Energy Saving status on the
display:
To bring a dispensing group out of the standby mode, press
andholdtherespective“PROG/STOP”buttonfor3seconds.
It will return to full operation in about 1-2 minutes.
Ifthemachineisin“ENERGYSAVING”mode,thesteamheat-
ing unit will also be reactivated, effectively exiting from the
"energy saving" mode.
The steam heating unit and the dispensing groups that have
been reactivated, will remain operative until the next time
limit set for the energy saving mode (machine) or the standby
mode (dispensing groups) to start-up has passed.
The system will continue to follow the energy saving settings
that have been programmed.
ThemachinecanalsobesettoOFFstatus,whichisindicated
by the following icon on the display:
Toreactivatethemachine,pressandholddownthe“PROG/
STOP”buttonfor3seconds.
Wait approximately 10 minutes for the coffee heating unit to
warm up and approximately 20 minutes for the steam heat-
ing unit to heat up.
If the machine is not used for a time which exceeds the limit
that has been programmed, the machine will return to the
OFFstatus.
To change the operating parameters of the "Ener-
gy saving" system, contact the Technician.
6.11.2 Dispensing group standby mode
When desired, one or multiple dispensing groups can be man-
ually put in standby mode.
To force the groups into standby mode:
• Press the button on the touchscreen display.
• Activate the groups that you would like to put in standby
mode on the next screen.
• Return to the main screen via the
button.
When the group has been put into standby mode, this will be
indicatedbythebeverageselectionLEDsturningoff.
To bring a dispensing group out of the standby mode, press
andholdtherespective“PROG/STOP”buttonfor3seconds.
Prog
Stop
Press and hold
down for 3 secs.
Groups
Standby