Asus P5M2 - Serial Port Connector (10-1 Pin Com); Sas Lsi1068 Ports Led Connector (18-1 Pin Sasled)

2-32
Chapter 2: Hardware information
6. Ser ial po rt con nec tor (1 0-1 pi n C OM2 )
This connector is for a serial (COM) port. Connect the serial port module
cable to this connector, then install the module to a slot opening at the back
of the system chassis. The serial port module is purchased separately.
7.
SAS LS I10 68 por ts LED co nne cto r ( 18- 1 p in SAS LED 1)
(
For P5 M2/SAS m ode l o nly )
This connector is for SAS link state’s LED. The active LOW Fault LED signals
are nominally congured to indicate a SAS link fault for each respective phy.
The active LOW Activity LED signals are nominally congured to indicate
SAS link activity.
P5M2/SAS
®
P5M2/SAS SAS LED Connector
SASL ED1
ACT _LED0 ACT _LED1 ACT _LED2 ACT _LED3 ACT _LED4 ACT _LED5 ACT _LED6 ACT _LED7
FL T_L ED0 FL T_L ED1 FL T_L ED2 FL T_L ED3
HB_LE D
FL T_L ED4 FL T_L ED5 FL T_L ED6 FL T_L ED7
P5M2 Series
®
P5M2 Series COM Port Connector
PIN 1
COM 2