Asus P5VDC-TVM SE - PnP;PCI Configurations

2-20 Chapter 2: BIOS setup
2.8.1 PNP OS Installed [No]
When set to [No], the BIOS congures all the devices in the system. When set to
[Yes] and If you install a Plug and Play operating system, the operating system
congures the Plug and Play devices not required for boot.
Conguration options: [No] [Yes]
2.8.2 Reset Conguration Data [Disabled]
If you installed an add-on device and the system reconguration caused a serious
conict such that the system cannot boot, set this item to [Enabled] to reset
Extended System Conguration Data (ESCD) when you exit Setup.
Conguration options: [Disabled] [Enabled]
2.8.3 Resources Controlled By [Auto(ESCD)]
Setting to [Auto] allows the BIOS to automatically congure all the boot and
compatible Plug and Play devices. You cannot confgure the IRQ DMA and memory
base address elds if you set to [Auto] because the BIOS automatically assigns
them. Conguration options: [Auto(ESCD)] [Manual]
2.8 PnP/PCI Congurations
The PnP/PCI Congurations menu items allow you to change the settings for
PnP/PCI devices.
Phoenix - AwardBIOS CMOS Setup Utility
PnP/PCI Congurations
Select Menu
Item Specic Help
Select Yes if you are
using a Plug and Play
capable operating
system. Select No if
you need the BIOS to
congure non-boot
devices
: Move Enter:Select +/-/PU/PD:Value F10:Save&Exit ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F9: Optimized Defaults
PNP OS Installed [No]
Reset Conguration Data [Disabled]
Resources Controlled By [Auto(ESCD)]
x IRQ Resources Press Enter
PCI/VGA Palette Snoop [Disabled]
Assign IRQ For VGA [Enabled]
Assign IRQ For USB [Enabled]
INT Pin 1 Assignment [Auto]
INT Pin 2 Assignment [Auto]
INT Pin 3 Assignment [Auto]
INT Pin 4 Assignment [Auto]
** PCI Express relative items **
Maximum Payload Size [4096]