Owner Installation Instructions DCB-05V2 Gate Controller 31
Fig I.1
Fig I.2
Fig I.3
Parameter Description
M1 Normal Open Time Sets Open drive time for M1
M1 Normal Close Time Sets Close drive time for M1
* M2 Normal Open Time Sets Open drive time for M2
* M2 Normal Close Time Sets Close drive time for M2
* Close Sync Delay Sets Delay before M1 is started on closed cycles
* Open Sync Delay Sets Delay before M2 is started on open cycle
* Only used for dual gate installations. Once the parameter values have be set
press EXIT and the main screen is displayed, the gate is ready for use.
20. Warranty and Exclusion of Liability
1. This Warranty is given by Dominator on behalf of Automatic
T
echnology (Australia) Pty Ltd (ABN 11 007 125 368) (ATA), Ph: 0800
366 462, info@dominator.co.nz
2. The Competition and Consumer Act 2010 (including the New
Zealand Consumer Law) and other relevant statutes provide a set of
statutory consumer guarantees and other legal rights that cannot be
excluded, restricted or modified by contract. This Warranty is in addition
to and does not affect any of your rights under the New Zealand
Consumer Law and other relevant statutes.
3. Our goods come with guarantees that cannot be excluded under the
New Zealand Consumer Law. You are entitled to a replacement or refund
for a major failure and for compensation of any other reasonably
foreseeable loss or damage. You are also entitled to have the goods
repaired or replaced if the goods fail to be of acceptable quality and the
failure does not amount to a major failure.
4.
5.
(a)
Subject to your non-excludable rights under the New Zealand Consumer
L
aw, ATA expressly excludes any liability for consequential loss,
incidental or indirect damages (including but not limited to damages for
loss of business profits, business interruption and loss of business
information) due to a defect of the DCB-05V2 Control System (Product).
In particular any loss or damage caused to other equipment or accessories
used with the product or any loss resulting from a delay in repair is
excluded to extent permitted by law.
Subject to all of the matters set out below, ATA warrants in relation to the
Product that:
the Product’s drive units will be free of any defects in material and
workmanship for at least 24 months after the date of purchase (as evidenced
by the sales docket receipt),or 5000 cycles, which ever occurs firts and
(b) the Product’s other components and accessories will be free of any defects
in material and workmanship for at least 12 months after the date of
purchase (as evidenced by the sales docket receipt).
6. No additional warranty will apply for Products repaired during the relevant
warranty period.
7. For all Products repaired outside the warranty period, a six (6) month warranty
that the Product will be free of any defects in material and workmanship will
apply from the date of dispatch of the Product to you. ATA may charge
you for any repairs undertaken outside the warranty period, and will provide
you with a quotation in relation to any such costs for your approval before
proceeding with any repairs.
8. This Warranty applies only where you:
(a) immediately notify ATA at the contact details provided in paragraph 1
above or notify the or the retailer that you purchased the Product from of
the alleged defect;
(b) return the product to the retailer that you purchased the Product from; and
(c) present the relevant sales docket and this Warranty document to the retailer
to confirm the date of purchase.
9. Except for this Warranty, ATA gives no warranties of any kind whatsoever
(whether express or implied), in relation to the product, and, subject to
paragraph 1 above, all warranties of whatsoever kind relating to the product
are hereby excluded.
10. This Warranty excludes damage resulting from:
(a) normal wear and tear;
(b) accidental damage;
(c) incorrect installation of the Product;
(d) blown fuses, electrical surges, power surges or power spikes;
(e) theft, fire, flood, rain, water, lightning, storms or any other acts of God;
(f) any installation, configuration or use of the Product contrary to the
instructions supplied with the Product;
(g) the gate used with the Product not being in safe working order and
condition;
(h) repairs which are not authorised by ATA;
(i) any failure to install or maintain the Product in accordance with the
instructions supplied with the Product;
(j) any use which is not in accordance with the instructions provided with the
Product;
(k) deliberate or negligent damage to the Product;
(l) any unauthorised modification to the Product;
(m)faulty or unsuitable wiring in the building in which the Product is installed;
(n) damage caused by insects;
(o) any cost or expense relating to the recall of the Product;
(p) installation of a residential gate opener in a commercial or industrial
situation or in a dwelling other than a single-family dwelling;
(q) radio or electrical interference; or
(r) acts or omissions of any person (including service providers approved by
ATA) other than ATA.
11. ATA’s liability under this Warranty is limited, at ATA’s absolute option, to
replacing or repairing the product which ATA, in its unfettered opinion,
considers to be defective either in material and/or workmanship or to credit
the dealer with the price at which the product was purchased by the dealer.
12. This Warranty does not extend to cover labour for installation of the Product
following repairs, the cost of which must be borne by you.
13. This Warranty is limited to Return-to-Base (RTB) repair and does not cover
labour for on-site attendance, the cost of which must be borne by you.
14. Except as specified in this Warranty, ATA will not charge you for any repairs
or replacements conducted under the Warranty. However, ATA will charge
you for any repairs which are not within the scope of this Warranty (or which
are not required to be undertaken free of charge pursuant to the Australian
Consumer Law).
15. This Warranty is void if the Product is not returned to the manufacturer in
original or suitably secure packaging.
16. This Warranty is only applicable for repairs to the product carried out within
Australia.
17. This Warranty does not cover consumable items including, without
limitation, globes, batteries and fuses.
18. This Warranty is not transferable.
19. Where the Product is retailed by any person other than ATA, except for the
warranty set out above, such person has no authority from ATA to give any
warranty or guarantee on ATA’s behalf in addition to the warranty set out
above.
20. Any provision of this Warranty that is prohibited or unenforceable in any
jurisdiction is ineffective as to that jurisdiction to the extent of the prohibition
or unenforceability. That does not invalidate the remaining provisions of this
Warranty nor affect the validity or enforceability of that provision in any other
jurisdiction.
21. Products presented for repair may be replaced by refurbished goods of the
same type rather than being repaired. Refurbished parts may be used to
repair the Product.
NOTES:
1. One (1) cycle = one (1) open and one (1) close action of the door or gate.
2. This Warranty is to be read in conjunction with the owner’s copy of the
installation instruction manual.
To Next Page
Loading...
Need help?
General