ATA HiRO GDO-12 - How to Use Your Operator

20 HIRO Installation Manual GDO-12V1
7.1 How to Use Your Operator
Fig.7.1.1
REPLACE WITH BATTERY CR2032
Fig.7.1.2
CAUTION: Activate the operator only when the door is
in full view, free of obstructions and with the operator
properly adjusted. No one should enter or leave the
garage while the door is in motion. Do not allow children
to play near the door.
ATTENTION: Activez le dispositif de commande
uniquement lorsque la porte est en pleine vue, dégagée
et avec le dispositif correctement réglé. Personne ne doit
entrer ou sortir du garage pendant que la porte est en
mouvement. Ne pas laisser les enfants jouer près de la
porte.
WARNING! This operator has a grounding type plug
and there are no user serviceable parts inside this
operator.
AVERTISSEMENT! Ce dispositif de commande est
pourvu d’une broche de mise à la terre et ne comporte
aucune pièce réparable par l’utilisateur.
For maximum efficiency of your operator, your garage door must be in good operating condition.
An annual service of your garage door by door professional is recommended.
7.1.1 How To Operate the opener:
a. Press the programmed transmitter button until your door begins to move
(usually 2 seconds). Make sure you can see the door when you use the
transmitter (Fig 7.1.1).
b. If you are in a vehicle you should aim the transmitter through your windscreen
as shown.
c. Check that the door is fully open or closed before you drive in or away.
d. If you press the transmitter whilst the door is moving the door will stop. The
next press of the transmitter will move the door in the opposite direction.
7.1.2 Replacing the Battery: 3V Lithium Battery CR2032.
To test the battery is working, press and hold a Remote Control Transmitter
button. Check Light Status table to determine if battery needs replacing.
Light Status Battery Status
Solid OK
Flashing Requires replacement
No light Requires replacement
Remote Control Transmitter
a. Remove screw from back of cover.
b. Use screw driver to separate the transmitter casing to expose circuit board.
c. Use a non-metallic object (e.g. pen) to remove the battery. (Fig. 7.1.2).
Premium Wall Control
a. Follow instructions in Fig 7.1.3 to replace battery.
STEP TWO
Use pen to lift lid, then
push and release
battery
STEP ONE
lift lid,
slide up &
off screws
peel off
from velcro
OR
Replace battery and remount to wall.
Dispose of battery responsibly
Fig.7.1.3
WARNING! Chemical Burn Hazard. Keep batteries
away from children
AVERTISSEMENT! Risque de brûlure chimique:
Gardez les piles hors de portée des enfants.
WARNING! The Battery shall be disposed of properly,
including keeping them away from children. Even
used batteries may cause injury.
AVERTISSEMENT! La batterie doit être mise au rebut
de manière appropriée, notamment en la gardant hors
de portée des enfants. Même les piles usées peuvent
provoquer des blessures.