-10-
1. Tolerance Setting
Set
upper
and
lower
limits
for a
scale, and
the
indicator
will
light
up
to
notify
if
a
measurement
falls
within
or
outside
the tolerance.
Range: -999 to +999
Resolution
(regardless of positive or negative value)
:
> 100 : 1
10.0 to 99.9 : 0.1
< 9.99 : 0.01
[Factory default: lower limit = -5.00，upper limit = +5.00 in Angle of Rotation]
Confirm the scale.
Confirm the upper limit.
How to access the setting (rpage 9)
G
F
Brix (%)
Concentration Specific Rotation
F
F
Purity
International Sugar Scale
①J→While ⑴ is flashing
a
Select the sign by K or H .
②J→While ⑵ is flashing
a
Increase the value by K .
a
Decrease the value by H .
③J→While ⑶ is flashing
a
Choose to insert a decimal point by
K or H .
④J→While ⑷ is flashing
a
Same as ② above.
⑤J→While ⑸ is flashing
a
Same as ③ above.
⑥J→While ⑹ is flashing
a
Same as ② above.
⑵ Value
Enter the upper limit.
⑹ Value
⑸
⑷ Value
⑸
Enter the lower limit.
G
Return to the measurement mode.
G
Confirm the lower limit. “” will flash on the display.
Exit the setting.
N Press G to continue to edlit
the setting.
m
A tolerance can be set for no
more than 1 scale at a time.
N The tolerance range is different
from the display range.
m Set the upper and lower limits to
0.00 to turn off the measurement
evaluation indicator.
N The last used scale will be
selected upon returning to the
measurement mode.
⑴
Sign
When cancelling settings, press
.
to lower limit value input.
N
When cancelling settings,
press
F
.
To Next Page
Loading...
Need help?
General
