AT&T DLP73410 - Number of Rings

128
Answering system
Answering system settings
Number of rings
Youcansettheansweringsystemtoansweranincomingcallaertwo,three,
four,ve,orsixrings.Youcanalsoselecttollsaver,whichisexplainedbelow.By
default,theansweringsystemanswersanincomingcallaerthreerings.
To set the number of rings:
Using a cordless handset or telephone base:
1. Press MENU/SELECT in idle mode.
2. Press CID or DIR to highlight Answering sys, then press
MENU/SELECT.
3. Press CID or DIR to highlight Ans sys setup, then press
MENU/SELECT.
4. Press CID or DIR to highlight # of rings, then press
MENU/SELECT.
5. Press CID or DIR to choose from 6, 5, 4, 3, 2 or Toll saver.
f Tollsaver-theansweringsystemanswersacallaertworingswhenyou
havenewmessages,oraerfourringswhenthereisnonewmessage.
This feature allows you to check for new messages and avoid paying long
distance charges when calling from out of your local area.
6. Press MENU/SELECT to save.
Note: If Smart call blocker is on, the rst ring of all calls will be muted.
# of rings
ECO
3
ECO