AT&T DLP73410 - Message Recording Time

130
Answering system
Answering system settings
4. Press CID or DIR to highlight Msg alert tone, then press
MENU/SELECT .
5. Press CID or DIR to choose On or O, then press
MENU/SELECT .
Notes:
f To temporarily turn o the message alert tone, see page 134.
f The message alert tone beeps only if all the following conditions are met.
– Answering system is on.
– Message alert tone setting is on.
– There are new messages.
Message recording time
You can set the recording time allowed for incoming messages. The message
length is three minutes by default.
To change the setting:
Using a cordless handset or telephone base:
1. When the handset or telephone base is in idle mode, press MENU/SELECT to
enter the main menu.
2. Press CID or DIR to highlight Answering sys, then press MENU/SELECT .
3. Press CID or DIR to highlight Ans sys setup, then press MENU/SELECT .
4. Press CID or DIR to highlight Recording time, then press MENU/SELECT .
5. Press CID or DIR to choose On or O, then press MENU/SELECT .
6. Press CID or DIR to choose 3 minutes, 2 minutes or 1 minute, then press
MENU/SELECT tosavethesetting.Youhearaconrmationtone.
Msg alert tone
ECO
Off
ECO