AT&T DLP73410 - Make an Outgoing Call During PTT Call; End or Leave a PTT Call

76
Multiple handset use
Push-to-talk (PTT)
Make an outgoing call during PTT call
f During a one-to-one PTT call, press HOME/FLASH on your handset or
/HOME on your telephone base to get a dial tone. The PTT call
ends automatically.
f During a one-to-group PTT call, press HOME/FLASH on the initiating
handset or /HOME on the initiating telephone base. The PTT call ends
automatically and you get a dial tone.
f During a one-to-group PTT call, press HOME/FLASH on any one of the
destination handsets or press /HOME on the destination telephone base.
That device gets a dial tone. The PTT call continues for the rest of the PTT
participants.
End or leave a PTT call
For one-to-one PTT calls, both initiating and destination devices can end the
PTT call. For PTT calls to multiple devices, the initiating device can end the PTT
call. If any one of the destination devices leaves the PTT call, the call continues
until all participants or the initiator hangs up.
Press OFF/CANCEL on the handset, or press CANCEL on the telephone base.
The screen shows Push to talk Ended.
-OR-
Place the handset in the telephone base or charger, then the handset returns
to idle mode.
Note: After PTT on the handset or PTT/FLASH on the telephone base is released, the PTT call remains open for
a short time. If no one presses PTT on the handset or PT T/ FLASH on the telephone base within ten seconds,
the PTT call ends automatically.