115
Smart call blocker
Call block settings
Voice guide to set Smart call blocker
This feature is an easy and alternative way for you to do the basic setup of
Smart call blocker. You can follow the voice guide to set your telephone system
to allow or to screen all incoming home calls, or to screen home calls that do
not display a phone number.
1. Press CALL BLOCK on the telephone base to enter the
call block menu when in idle mode.
- OR -
Press MENU/SELECT to enter the main menu when the
telephone is not in use. Then, press CID or DIR to scroll
to Smart call blk. Press MENU/SELECT.
2. Press qCID or pDIR to scroll to Voice guide, then press
MENU/SELECT.
3. You hear a voice prompt “Hello! This voice guide will
assist you with the basic setup of Smart call blocker...”
4. Set up your Smart call blocker feature by inputting the designated numbers,
as instructed in the voice guide.
f Press 1 if you want to screen home calls with telephone numbers that are
not saved in your directory, allow list or star name list; or
f Press 2 if you do not want to screen calls, and want to allow all incoming
calls to get through.
Notes:
f The screening feature of Smart call blocker is applicable to home calls only. All incoming cell calls will get through and ring. If
you want to block a cell call, add the number to the block list. See Block list on page 101.
f You can press CANCEL on the telephone base to quit the voice guide at any time.
f After a power outage, the telephone base prompts you to set the date and time. After the date and time setting is
done or skipped, the telephone base will prompt if you want to set up Smart call blocker via voice guide. Press
MENU/SELECT to start the setup.
Screening annc
>Voice guide
Answering sys
>Smart call blk
To Next Page
Loading...
