AT&T DLP73410 - Device List and Connection; Review the Device List; Connect;Disconnect an Active; Device

27
Bluetooth
Bluetooth setup
Device list and connection
Up to 2 devices can be paired to the telephone base. All paired devices are
shown on the device list. To use a paired device, it must be connected. Both
Bluetooth enabled devices can be used on a cell call at a time.
Once you have paired a device with the telephone base, you do not need to
repeat the pairing procedure again unless you delete the device from the
device list.
Note: When connecting a Bluetooth device to the device list, all connected devices will be temporarily
disconnected until the procedure is complete. It may take up to two minutes to reconnect.
Review the device list
1. Press MENU/SELECT on the telephone base when the
telephone is not in use.
2. Press CID or DIR to highlight Bluetooth, then
press MENU/SELECT.
3. Press MENU/SELECT again to select Device list.
Connect/disconnect an active device
While in the device list menu, you may connect or disconnect your
active device.
1. Press MENU/SELECT on the telephone base in idle mode.
2. Press CID or DIR to highlight Bluetooth, then press MENU/SELECT.
3. Press CID or DIR to highlight Device list, then press MENU/SELECT.
4. Press CID or DIR to highlight a device, then press MENU/SELECT.
5. Press CID or DIR to highlight Connect/Disconnect (whichever is
applicable), then press MENU/SELECT . The telephone base displays Device
connected/Device disconnected.Youhearaconrmationtone.
Note: When your active device is connected, you are prompted to select Disconnect. When your active device is
disconnected, you are prompted to select Connect.
Intercom
>Bluetooth
BLUETOOTH
>Device list