AT&T DLP73410 - Message Playback

129
Answering system
Answering system settings
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access
code is 19.
To change the remote access code:
Using a cordless handset or telephone base:
1. Press MENU/SELECT in idle mode.
2. Press CID or DIR to highlight Answering sys, then press
MENU/SELECT .
3. Press CID or DIR to highlight Ans sys setup, then press
MENU/SELECT .
4. Press CID or DIR to highlight Remote code, then press
MENU/SELECT .
5. Use the dialing keys to enter a two-digit number.
-OR-
Press CID or DIR to scroll to a desired two-digit number.
6. Press MENU/SELECT toconrm.
Message alert tone
When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every 10 seconds. The tone stops when all
new messages have been reviewed. By default, the message alert tone is O.
To turn on or o the message alert tone:
Using a cordless handset or telephone base:
1. Press MENU/SELECT in idle mode.
2. Press CID or DIR to highlight Answering sys, then press MENU/SELECT .
3. Press CID or DIR to highlight Ans sys setup, then press MENU/SELECT .
Remote code
ECO
Remote code
19
ECO