AT&T DLP73410 - Page 71

65
Multiple handset use
Intercom
Using the telephone base:
1. Press INT on the telephone base.
-OR-
Press MENU/SELECT on the telephone base in
idle mode, then press CID or DIR to highlight
Intercom. Press MENU/SELECT .
2. Press CID or DIR to select a device. The
telephone base shows Calling HS X (X
represents the handset number). The destination handset
rings and shows Base is calling.
To answer an intercom call with the telephone base:
f Press /HOME or /CELL on the telephone base . Both
devices now show Intercom.
To end an intercom call with the telephone base:
f Press CANCEL on the telephone base.
Notes:
f For cordless headsets, refer to the corresponding user’s manual on how to answer and end an intercom call.
f If the destination device does not answer the intercom call within 100 seconds, or if the device is in use, on a call,
or out of range, the initiating telephone base displays No answer, try again, or the initiating handset displays
Unable to call, and returns to idle mode.
f To temporarily silence the intercom ringer, press OFF/CANCEL or MUTE/DELETE on the destination handset/
headset, or press CANCEL on the telephone base.
f You can only use one pair of devices at a time to make intercom calls.
INTERCOM TO:
> HANDSET 1
Calling
HANDSET 1