Syn248 Installation and Configuration Guide Back to Contents
Device Configuration 95
If an upgrade is available, the Found New Upgrade screen appears. Press
to install the upgrade or press to return to the Admin Settings
menu.
If no upgrade is available, the No New Version screen appears. Press
to return to the Admin Settings menu.
The Deskset automatically resets at the end of the software upgrade process. If a PC is
connected to the Deskset that you are using, any network traffic involving that PC halts
until the Deskset has resumed operation. Avoid updating the Deskset when the user is
likely to be at the workstation.
See “Updating Devices” on page 74 to update the Deskset software from the WebUI.
Set Time and Date
You can set the system time and date using a Deskset. To set the system time and date
from the WebUI, see “Changing the System Basic Settings” on page 39.
To set the System time and date:
1. On the Admin Settings menu, press 6 to display the screen shown below.
2. Press
or to select the Clock source. You can set the system time to follow a
Network Time Protocol (NTP) Server (recommended) or you can set the time and date
manually.
If you select NTP Server, the manual time and date settings disappear from the
screen. Ensure that you have configured the NTP Server on the WebUI. See
“Changing the System Basic Settings” on page 39.
3. If you select Manual, use the dial-pad keys and press
or and or to
manually set the Date, Time, Time Zone and Daylight Savings.
4. Press to return to the Admin Settings menu.
If the device is sluggish or unresponsive during the upgrade process, see “A
Syn248 device becomes sluggish or unresponsive during or immediately
after software upgrade.” on page 112.
Set Time and Date
Manual
Date (M/D/Y): 06 / 15 / 2011
Use or to move highlight.
Use or to cycle through options.
Save
Time: 3 : 45 [PM]
Time Zone: [Pacific]
Clock source:
Daylight Savings: [Yes]
Quick
Dial
SB35031 Deskset SB35025/SB35020 Deskset
To Next Page
Loading...
