Syn248 Installation and Configuration Guide Back to Contents
System Configuration 51
Overhead Paging
To set up external overhead paging:
1. In the navigation menu at left, click Overhead Paging. The Overhead Paging
Configuration page appears.
2. Enable or Disable the overhead Paging. When overhead paging is enabled,
“Overhead Page” appears as an available Paging Zone member on the Create/Edit
Paging Zone WebUI page. See “Creating a Paging Zone with Overhead Paging” on
page 52 and “Creating, Editing and Deleting Paging Zones” on page 55.
3. Select the AUX I/O Port, which is the extension number of the SB35025 Deskset to
which the overhead paging system is connected. All SB35025 Desksets installed in
the Syn248 system appear in the list.
4. Click to save these settings or click to return to the previous page
without saving the changes.
The Overhead Paging Configuration page does not appear if there are no
SB35025 Desksets connected to the system.
To Next Page
Loading...
