IPPBX IP2G4A User Manual
~ 37 ~ ATCOM TECHNOLOGY CO., LIMITED
6.3 Make inbound calls
Go to PBX Settings -> Inbound Routes, click to add an inbound route. Just setting Selected Trunks
and Path is OK.
1) General
Caller ID
Define the Caller ID number to be matched on incoming calls. Leave this field blank to match any or no CID info.
Special characters described in chapter 5.2 can be used here as same.
DID number
Just leave it blank.
Extension
It’s unavailable for Analog / GSM trunk, leave it blank.
2) Inbound Trunk Selection
To Next Page
Loading...