Atlas Copco MT Focus 6000 - Page 11

MT Focus 6000 EN Installation
© Atlas Copco Industrial Technique AB - 9839 0470 01
11
Pin Signal Description
5 GND Ground
Fieldbus
Not implemented yet.
COM
3-pole socket connector for the serial interface.
COM port settings: 115200Baud, 8Data bits, 1Stop bit, No parity, No hand-
shake.
Use a 3-pole pin plug from the Binder 719 Series. Complies with RS-232.
Pin Signal Description
1 TxD Transmitted data
2 GND Data ground
3 RxD Received data
I/O - BUS
Not implemented yet.
IAM MT
The IAM MT (Intelligent Application Module MicroTorque) is a memory card
for application software and result storage.
The IAM MT may store:
• Necessary software for the MTF 6000
• Configuration data
• Result database
• Trace database
• License and MAC-address.