Atlas Copco MT Focus 6000 - Page 8

Installation EN MT Focus 6000
8
© Atlas Copco Industrial Technique AB - 9839 0470 01
Pin I/O
15 DI 3
16 DI 4
17 DI 5
18 DI 6
19 DI 7
20 DI 8
21 DI 9
22 DI 10
23 DI 11
24 DI COMMON 0-5
25 DI COMMON 6-11
26 GND
Pulse length must be minimum 20 ms.
All inputs are opto isolated.
Interface connection can be connected in PNP mode (source type, positive
logic), or in NPN mode (sink type, negative logic).
PNP and NPN mode can, if required, be mixed bank wise (for example DO
COMMON 0-3 PNP and DO COMMON 4-7 NPN).
PNP mode
I/O Description
+24V IO +24V output