30
E240 Password Incorrect
Input Source
- The password is entered from an
invalid source according to the
confi guration.
E250 Maxtime for fi rst tighten-
ing run out (job)
- This message is displayed and the job
is terminated if the fi rst tightening is not
performed within the specifi ed time.
E251 Maxtime to complete
job run out
- This message is displayed and the job
is terminated if the job is not completed
within the specifi ed time.
E300-E399: Statistical errors
E333 Not allowed subscription - The requested statistic subscription is
not allowed. For example it is not allowed
to set an angle statistic subscription
for a Pset using only the torque control
strategy.
E334 No statistic available for
this Pset
- The Pset strategy is not suitable to
calculate statistics (no strategy is chosen,
DS control)
E335 Not enough data - Not enough data were available to
calculate the statistic control limits.
E336 Mem alloc fail - It was not possible to allocate enough
memory for the statistic subscription.
E340 Xucl tq - The last subgroup mean torque value is
larger than the upper control limit.
E341 Xlcl tq - The last subgroup mean torque value is
lower than the lower control limit.
E342 Rucl tq - The last subgroup range torque value
is larger than the upper control limit.
E343 Rlcl tq - The last subgroup range torque value
is lower than the lower control limit.
E344 Cp tq - The torque Cp is lower than 2.
E345 Cpk tq - The torque Cpk is lower than 1.33.
E346 7inc x tq Trend deviation alarm – the subgroup
torque mean value has increased 7
times in a row
E347 7dec x tq Trend deviation alarm – the subgroup
torque mean value has decreased 7
times in a row
E348 7inc x r Trend deviation alarm – the subgroup
torque range has increased 7 times
in a row
To Next Page
Loading...
Need help?
General
