Atlas Copco Power Focus 600 - Software Update Methods; Software Update from USB; Software Update from Web Interface; Controller Software Activation

EN Power Focus 600
20
© Atlas Copco Industrial Technique AB - 9836 4954 01
Installing a second version of the controller software can be useful when per-
forming upgrades on multiple controllers. When production is ready for chang-
ing to the upgraded software, activation of the new software version can be
made locally on the controller or from a remote computer.
A new software distribution can be installed either by connecting a USB flash
drive containing the software to the controller’s USB port or by using the web
interface.
Note! The Software update option is only visible when
browsing to the controller interface from a PC. The
user will be prompted to update the software when in-
serting a mass storage device with a valid software
version in the USB port
After the installation the user is prompted to activate the software. See Con-
troller software activation [Page000].
Note! The software update file must not be unzipped and
must be stored in a folder named PFImages in the
root on the USB flash drive.
Software update from USB
The installation wizard will start automatically when connecting the USB flash
drive to the controller. Follow the instructions to finish installation.
Software update from Web interface
To install the software from the web interface:
1. On the Controller menu, go to Software, and then select Software update
and click Choose File.
2. Browse and choose the software upgrade file and follow the instructions to
finish installation.
Controller software activation
Controller > Software > Software activation
The controller can store two installed software versions. By using the Software
activation it is possible to choose which software version to use. Software acti-
vation can be performed either locally from the controller or remotely from a
web-browser.
Note! The activation process requires a restart of the con-
troller.
To activate the installed software:
1. On the Controller menu, go to Software, and then select Software activa-
tion.
2. Press OK to start activation, and follow the instructions.