Atlas Copco Power Focus 600 - Reports; Results; Events; NOK Ratio

Power Focus 600 EN
© Atlas Copco Industrial Technique AB - 9836 4954 01
21
Reports
The Power Focus 600 can store up to 1000 individual tightening results and
events, depending on IAM type, on the IAM device. The reports and events can
also be exported as comma separated files to a PC or USB-device. For more in-
formation on the Export/Import function, please refer to the section Export/Im-
port [Page000].
Results
The information stored is the tightening status (OK/NOK), date and time of the
performed tightening, and the resulting torque value.When the list is full the
oldest result value will be overwritten when a new tightening is performed.
Events
The information stored is date and time when the event occured, the event id or
event code to identify the specific event, event description and severity of the
event. When the list is full the oldest event value will be overwritten when a
new event occurs.
NOK ratio
NOK ratio lists the ten Psets with the highest ratio of NOK tightenings. The list
can be reset at any time.
Tightening setup
The Power Focus 600 tightening programs need parameters to be set in order to
perform a tightening, such as the Target torque or Target angle. Other set-
tings are optional such as Soft start, Selftap, and Torque compensation, or
which tightening strategy to use. It is also possible to monitor the tightening as
it progresses by adding limits in which the torque, or angle the nut turns, should
keep within.
The tightening procedure is divided into four stages; Start, Rundown, Tighten-
ing and Stop.