Atlas Copco Power Focus 600 - Page 46

EN Power Focus 600
46
© Atlas Copco Industrial Technique AB - 9836 4954 01
Event
Description Procedure Ack.
Code Type Name
2030 Error Tool memory
corrupt – Ser-
vice tool
Service tool x
2041 Error Torque trans-
ducer error
Will be gener-
ated either on
shut calibration
failure or if tool
reports trans-
ducer error.
Service tool
2042 Error Angle trans-
ducer error
Service tool x
2043 Error Ground error Service tool x
2044 Info Tool service in-
dicator
Indicates that
service of tool is
needed. Service
e.g. triggered
when number of
tightenings has
exceeded set
tightening ser-
vice interval.
Perform service
of tool
2045 Warning Tool calibration
data invalid
If validation of
calibration data
fails.
Service tool
2046 Info Tool calibration
indicator
Indicates that
calibration of
tool is needed.
Triggered when
calibration
alarm is enabled
in settings and
the current time
is greater than
next calibration
date.
Service tool
2050 Error Tool Motor Ctrl
Data Invalid
Tool parameters
are need is miss-
ing.
Update tool pa-
rameters.
2060 Info Unexpected trig-
ger behaviour
Used to prevent
automatic start
of tool if acces-
sory is con-
nected.
2070 Info Tool not li-
censed
Tool is not li-
censed/sup-
ported.
2071 Error Corrupt tool de-
scriptor
Tool descriptor
is corrupt.