Atlas Copco SmartROC T45--10

SmartROC T45-10 4 Operation
37
3.
Putthewinchdisengagementswitchintheunlockedpositiontodisengagethewinch
drum.
4.
Pulloutthecableandattachtheeyelettotheanchoragepoint.
WARNING
TippingRisk
Thetippingoverofamachinecancauseseriousinjuryordeath.
u Theanchoragepointmustbefirmandsecure.Payattentiontolocal
regulations.
u Neveruseadamagedcableorhook.
u Thesafetyhookmustnotbeabletoslideordetachfromthean
choragepoint.
5.
Putthewinchdisengagementswitchinthelockedposition.
6.
Setthewinchpressureregulatortothedesiredpressurewiththefingerswitcheson
thewinchcontrolunit.
7.
Activatethewinchcircuit onthewinchcontrolunit.
8.
Activatewinchpowerinmanually toensurethatthelockingmechanismengages
fullywiththedrumbeforeputtingaloadonthewinch.
9.
Reverseup/tramdowntheinclineusingthetramminglevers.Makesurethattheca
bleiskepttautconstantly.
10.
Adjustthepressureforthewinchmotortoachievesufficienttraction.
4.2.9CheckingafterTramming
Allemergencystopsmustbecheckedforproperfunctionaftertramming.