Atlas Copco SmartROC T45--10

SmartROC T45-10 6 Daily Maintenance
61
6.2.2WashMachineExternally
n
Rinsethemachinewithwateratleastonceadaytoremovedrillcuttings,mud,and
dirt.
Thefeed,frontpartoftheboom,andtrackframesareparticularlyimportanttokeepclean.
6.2.3CheckLubricationOilLevelTank
Thelubricatingoiltankismountedontheleftsideofthemachineframe.
n
Checkthetankandconnectionsforsignsofleakage.
n
Makesurethelubricationoillevelisabovethetopsightglass(B).
n
Refillwithlubricationoil(A,)ifnecessary.Alwaysuseafunnelwithastrainer.
!
NOTE:Thelubricationoillevelshouldnotbebelow40mm(1.6").Ifthelubricatingsys
temiscompletelydrained,thesystemwillhavetobebled.
6.2.4DrainCondensateinPressureTank
A Compressortank
B Compressorcooler
C Compressorelement
Condition
p
Themachinemusthavebeenswitchedoffforatleast1hour.