- 71 -
SETTINGS
For buttons to be used see “Control Panel”
Acknowledge an Alarm
If an alarm becomes active, for example a Low Fuel
Level Warning:
then this alarm can be acknowledged by pressing the
ENTER button. If the fuel level is still low, the view
will change to:
As soon as the fuel level is higher than the warning
level, the alarm icon will automatically disappear.
As long as there is an alarm icon in the middle of the
bottom part of the view, all active acknowledged / un-
acknowledged alarms can be seen by pressing the
ALARM VIEW button
Pressing the ALARM VIEW button again, will bring
you back to the Main View.
Set Clock
Press the SETTINGS VIEW button
• scroll to ‘1000 GENERAL SETTINGS’
• press ENTER
• scroll to ‘1290 DATE/TIME’
• ENTER the Date/Time menu
• scroll to the parameter you want to change
• ENTER this parameter.
To change the ‘RTC Month’, scroll to the preferred
month and press ENTER.
To change any other RTC setting, the red figure is
editable.
Scroll up/down and press ENTER to change. Use left/
right to shift between editable figures.
Now press BACK until you’re back in the Main View
(or in the menu you require).
Set Language
Press the SETTINGS VIEW button.
• scroll to ‘1000 GENERAL SETTINGS’
• press ENTER
• scroll to ‘1300 LANGUAGES’
• ENTER the LANGUAGES menu,
• ENTER the ‘SETTINGS’ parameter
• scroll to the preferred language
• press ENTER.
Now press BACK until you’re back in the Main View
(or in the menu you require).
Set Units
Press the SETTINGS VIEW button,
• scroll to ‘1000 GENERAL SETTINGS’
• press ENTER
• scroll to the unit you would like to change:
‘1340 TEMPERATURE UNITS’
‘1350 PRESSURE UNITS’
‘1360 FUEL FLOW UNITS’
‘1370 AIR FLOW UNITS’
• ENTER the preferred menu
• ENTER the ‘SETTINGS’ parameter
• scroll to the preferred setting
• press ENTER.
Now press BACK until you’re back in the Main View
(or in the menu you require).
To Next Page
Loading...
Need help?
General
