EasyManua.ls Logo

ATS Pyro-Clean - Operation; Important Operation Notifications; Warnings (Yellow); Alarms (Orange)

ATS Pyro-Clean
49 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26 MAN - Pyrolytic Oven - REV: Original | F. Operation
F. Operation
F.1 Important Operation Notications
There are several notications that may appear when operation of the Pyrolytic Oven is initiated. These are broken
into three categories of severity: warnings, alarms, and faults. DO NOT IMMEDIATELY SHUT THE MACHINE
DOWN WHEN THESE NOTIFICATIONS APPEAR. Allow unit to continue cycle to completion. If the unit is required
to shut down, it will do so on its own.
Warnings, alarms, and faults are color coded in yellow, orange, and red. Refer to the list below for descriptions of
these common operation notications. If additional assistance is required, contact the ATS Service Department at
+1-724-283-1212.
Warnings (Yellow)
These do not stop the cycle but are things that you may wish to check after it is complete. Do not shut the machine
down if these appear. They may indicate:
6 Month Clean Warning
1 Year Catalyst Replacement Warning
Low Draft Warning
Alarms (Orange)
These do not stop the cycle but are things that should be checked before next cycle. Do not shut the machine down
if these appear. They may indicate:
Low Draft Alarm
Faults (Red)
These are faults that will automatically stop the current cycle. They must be xed before next cycle.
Oven Chamber Over-Temp
Oxidizer Chamber Over-Temp
Oven Chamber Over-Press
Standardization Error
Door Lock did not Engage
Draft Inducer Error
Low Draft Fault
F.2 Initial Start-Up: Empty Load
Do not operate the oven with a load if the correct, slight negative draft/pressure in the oven chamber is not
achieved. Refer to Installation Instructions or call the ATS Service Department at +1-724-283-1212 for technical
assistance.

Table of Contents

Related product manuals