40
wire feeding, if the wire feeding is turned on, the wire will be fed
automatically during the light emitting process, and the wire will stop
automatically when the light is stopped.
"Wire feeding direction" button: It can be switched to wire feeding and
wire return. In the automatic wire feeding mode, the wire feeding direction is
"Wire feeding" and cannot be modified.
Description of welding interface parameters:
"Scanning frequency”: Set the oscillation frequency of the galvanometer
motor of the gun head. The higher the scan frequency is set, the faster the
light spot moves.
"Scan width": set the beam swing width;
"Blowing before light": Set the delay time of blowing out before light is
emitted;
"Blowing after turn off light": set the blowing delay time after turning
off the light;
"Peak Power": The maximum power during stable light emission.
"PWM frequency": Adjust the frequency of the PWM pulse signal of the laser.
"PWM Duty Cycle": Adjust the duty cycle (pulse width) of the PWM pulse
signal of the laser. The power of the welding head is adjusted by the peak power
and the PWM duty cycle.
Welding head output power = laser power * peak power * PWM duty cycle.
"Wire feed speed": Set the running speed of the wire feeder.
"Blow before light emitting": Set the delay time of blowing before light is
emitted.
"Blow after light off": Set the delay time for blowing after light off.
Light emitting must meet the following 5 conditions at the same time:
To Next Page
Loading...