AUDAC AMP523 - Page 19

19
Mute button
BelowtheinputchannelselectionbuttonsisabigMUTEbuttonprovided,byclicking
thisbuttontheoutputsignalwillbecompletelysupressed.Whenthesignalismuted
thisbuttonwillturnRed.Theoutputcanbeunmutedafterclickingthisbuttonagain.
Volume Control
Theoutputvolumecanbesetbymovingthemasterfaderupanddown.Themaster
faderisindicatedwith“Output”locatedontherightsidenexttotheinputselection
buttons.Atthetopandbottomsideisabuttonwithanarrowdisplayedwherebythe
volumecanberaisedandloweredinstepsof1dB.
Mixing faders for WLI and MIC/WMI
Ontheleftsideofthemainscreentherearetwomixingfadersdisplayed.Withthese
faders,thesignalscomingfromtheadditionalwallpanelinputscanbemixedwith
eachother.ThemixingwithWLIandMIC/WMIchannelsis50%andthelevelcan
beadjustedwithbothfadersbetween0dBand-∞dB.Thiscanbeeasilydoneby
slidingthefadersupanddownorbypressingthearrowedbuttonsontopandbottom
ofthefaders.Thiswaythelevelcanberaisedandloweredinstepsof1dB.
Two band tone control
Ontherightsideofthemainscreentherearetwofadersdisplayedwhicharemeant
toadjustthesoundsettingsthroughtwo-bandtonecontrol.Theleftmostfader
indicatedwith“Bass”offersthepossibilitytoadjustthelevelofthelowfrequencies,
whiletherightmostfaderindicatedwith“Treble”offersthepossibilitytoadjustthe
levelofthehighfrequencies.Thesoundlevellevelforbothlowandhightonescan
amplifiedorattenuatedbetween+14dBand-14dB.
Configuration menu
Inthetoprightcornerisa“Setup”buttondisplayed.Afterclickingthisbutton,youwill
beredirectedtothegeneralconfigurationmenuoftheAMP523/RM523.
Save
Pressthe“Save”buttoninthetoprightcornerwhenanychangesaremadeto
thesettingsonthemainscreen.Otherwiseallsettingswillbesettodefaultafter
reloadingtheweb-basedinterface.