ffl..__ H_o_m_ e_L_i_n_k_® _______________________________________________ _
Applies to vehicles : with Home li nk® universa l remote cont rol
Programming the Homel ink ® transmitter
The transmitter is programmed in two phases. For rolling
code transmitters, a third phase is also necessary.
,,,,, r · o: o "'J '''"
Fig. 155 Overhead
console: Homelink®
keypad
Fig. 156 Radiator
grille
Phas e 1 : programming the o v erhead ke yp a d
1. Make sure your vehicle is within operating range of the
remote controlled garage door opener.
2 . Set the parking brake =>
& in "General information" on
page 159.
3. Turn the ignition on. Do not start the engine!
4 . Press and hold the two outside Homelink ® buttons
G) and
@ for approximately 20 seconds until indicator light @
=> fig.
155 begins to flash . Then release both buttons. Do
not hold the buttons for longer than
30 seconds .
- This procedure on ly needs to be performed
once. It erases
the factory-set default codes and does not have to be
repeated to program additional remote controls .
5. Press and hold the Homelink ® button
G), @ or @ until
the indicator light @ starts flashing
slowly . Release the
button.
- The system will remain in programming mode for 5
minutes. Co to the front of the vehicle and proceed with
phase
2 .
Phase 2: at the radiator grille
6. Point the original remote control to the middle of the
radiator grille of your vehicle => fig .
156.
7 . Hold the original remote control at a distance between O-
S in. (0-13 cm) (use the shortest distance possible).
8 . Press and hold the act ivation button on the remote
control.
- May be different in Canada . If so, press and re-press
(cycle) the activation button on your remote control every
two seconds.
9. The emergency flashers will flash
three t imes (after about
15-60 seconds) when the programm ing is successful.
Release the button on the remote control.
- To program more devices, repeat steps 4 to 9.
To Next Page
Loading...
