___________________________________________________ H_ o_m __ e_L_i_n_k_®_R_--J_
10. Press and hold the trained Homelink ® button and
observe the indicator light©~
page 160, fig. 155 .
- If the indicator light is solid/continuous, programming is
complete and your device should activate when you press
and release the trained Homelink ® button.
- If the indicator light blinks rapidly for 2 seconds and is
then a solid/continuous light, proceed with phase 3 to
program a rolling code device .
Ph a se 3: rollin g code progr a mm ing
- A second person on a ladder who can safely reach the
garage door opener motor is recommended.
11. Locate the "learn" button on the garage door opener
motor (refer to the operating instructions for the opener,
as the location of this button may vary by manufacturer) .
12. Press and release the learn button on the garage door
opener motor.
- Note: once the button is pressed, there are 30 s econds in
which to initiate the next step.
13. On the Homelink ® keypad inside the vehicle, firmly press
and hold the Homelink ® button previously programmed
in phases 1 and 2 for two seconds and release. Repeat this
sequence
twice .
- Some vehicles may require the press/hold/release
sequence up to three times to complete the training
process.
- HomeLink® should now activate your rolling code
equipped device.
Cont rols and equip-
ment
Vehicle OP-eration
If the 5 minute time limit is exceeded, the emergency fla shers w ill
fla sh one t im e
to indicate that the process has been terminated. In
this case, repeat steps 4 through 9.
If the emergency flashers do not flash
three times (after about 15-
60 seconds), programming was not successful. In this case, repeat
steps 4 through 9.
Remote control un its for garage door openers in Canada are set to
stop transmitt ing radio frequency signals after two seconds. This
time may not be sufficient for the Home link ® system to learn the
rad io frequency signal. Perform all other steps as described above . •
Applies to veh icles: with Homelin k® universal remote cont rol
Operating the Homelink ® transmitter
The HomeLink ® transmitter works in the some manner as
the original hand held remote control that come with the
system.
,,,,, r , o: o "',
11111
@
8
Fig. 1 57 Overhead
console: Homelink®
keypad
- Press the appropriate programmed button G), @ or@
to activate the desired remote control function
~
& in
"General information" on
page 159. •
Vehicle care Do-it-yourselt service iTechnical data
To Next Page
Loading...
