- To continue timing, press the upper section of the wiper
switch @ .
If timing is paused, you can continue it later even if you sw itch the
ignition off. •
Applies to vehicl es: with lap t imer
Evaluating times and continuing or
resetting timing
You con evaluate the fastest, slowest and overage lop
times.
Fig. 19 Display: lap
t ime evaluation
- To evaluate lap times, press and hold the ( RES ET]
=> page 26, fig. 17 @ button for approximately 2
seconds. The display shows the fastest lap"+", the
slowest lap"-" and the average lap time "0".
- To continue tim ing for additional laps, press the wiper
switch @ .
- To reset the timer to zero, press and hold the (
RESET]
button again for approximately 2 seconds.
- To switch the lap timer off completely, press the [
RESET)
button briefly.
Cont rols and equip-
ment
Vehicle OP-eration
Dri v er inform a tion syst e m
(I) Tips
• Saved lap times cannot be individually deleted from the total
results.
• The saved lap timer values will not be lost after turning the igni-
tion off. •
Speed warning system
Overview
The speed warning system helps you to keep your driving
speed below a set speed limit.
Fig. 20 Disp lay: speed
warni ng syst e m
The speed warning system warns the driver if he exceeds a previously
sto red maximum speed. A warning tone will sound as soon as the
vehicle speed exceeds the set speed by about 3 mph (3 km/h) . At the
same time, a warning symbol appears in the display => fig. 20.
The speed warn ing system has
t wo warning t hreshold s that function
independently of each other and that have somewhat different
purposes: ..
Vehicle care Do-it-yourselt service iTechnical data
To Next Page
Loading...
