Audi TT 2010 - Lumbar Support; Head Restraints

Seats and storage
Applies to vehicles : with lum bar support
Lumbar support
The lumbar support can be adjusted to fit the natural
curvature of the occupant's spine.
Adjusting the curvature
Fig. 62 Front seat:
switch for lumbar
adjustment
- Push the forward depression on the switch shell ==> fig. 62
to
increase backrest curvature.
- Push the
rear depression on the switch shell to decrease
backrest curvature.
Adjusting the height
- Push the top depression on the switch shell to raise the
support in the backrest .
- Push the
bottom depression on the switch shell to lower
the support in the backrest .
& WARNING
Never adjust the lumbar support while the vehicle is moving. If
you adjust your seat while the vehicle is moving, you will be out of
& WARNING (continued)
position. Always adjust the lumbar support when the vehicle is
not moving. •
Head restraints
Adjusting head restraints , front seats
The head restraints must be adjusted properly to provide
protection .
Fig. 63 Driver's seat
head restraint:
adjusting the height
The head restraints on the front seats can be adjusted to
provide safe support to head and neck at the optimum
height. When optimally adjusted, the top of the restraint
should be level with the top of the head ==>
page 111, "Proper
adjustment of head restraints ".
Raising head restraint
- Grasp the side of the head restraint with both hands.
- Adjust the head restraints so that the top of the head
restraint is
at least level with your eyes or higher
==> fig . 63.