Audi TT 2010 - Warnings and Symbols

Speed warning 2 : setting a speed limit
Switches in the wiper arm are used to operate warning
threshold 2.
To stor e maximum speed
- Turn off the ignition.
N
~
-
w
...
a,
Fig. 22 W iper leve r:
Trip compute r cont rols
- Briefly press the button in the instrument cluster
:::::, fig . 21. The odometer and the digital clock are now illu-
minated.
- Press the button for at least 2 seconds. The currently
stored maximum speed appears in the display
or the
crossed out symbol for warning threshold 2, if no
maximum speed was set previously.
- Press the function selector switch in the wiper lever @
:::::, fig. 22 up or down to change the set value . Values run
up or down in steps of 6.2 mph (10 km/h).
To d e lete maximum sp ee d
- Turn off the ignition.
Cont rols and equip-
ment
Vehicle OP-eration
Dri v er inform a tion syst e m
- Briefly press the button in the instrument cluster
=:> page 28, fig . 21. The odometer and the digital clock are
now illuminated .
- Press the button for at least 2 seconds. The currently
stored maximum speed appears in the display.
Press the reset button in the wiper lever ® :::::,
page 29,
fig . 22 until the crossed out speed warning symbol for
warning threshold 2 appears in the disp lay.
A few seconds after the adjustment is completed, the illumination for
the odometer and the digital clock will go out.
[ i ] Tips
This warning threshold can a lso be controlled through the trip
computer~
page 24, "Navigat ing the menu" . •
Warnings and symbols
Red symbols
A red symbol means DANCER
- Pull of the road and stop the vehicle.
- Turn off the engine .
- Check the malfunctioning system . Contact your autho-
rized Audi dealer or a qualified workshop for assis t ance . .,_
Vehicle care Do-it-yourselt service iTechnical data