The tr ip computer o nly operates whe n the ignition is o n. When you
tu rn o n the ignit io n, t he fu nct ion that was in use whe n yo u last t ur ned
the ignition off will be d isplayed .
[I) Tips
• You can also set the values for the functions to zero in the menu
display
(Reset) ~ page 23.
• All stored values will be lost if the vehicle battery is
disconnected. •
Menu display
Introduction
Cont rols and equip-
ment
Fig. 12 Wiper lever :
Controls for the menu
display
Vehicle OP-eration
Driver information system
Fig. 13 Display: St art
me nu
Some funct ions in your vehicle can be set, act ivated, and contro lled
by
Menus (e.g. Acoustic park assist *). With these menus you can also
se lect the informat ion shown in the drive r information sys t em, which
operates only with the ignition sw itched on. Operation is contro lled
by t he [Reset] but ton and the rocker sw itch on the w iper lever
~
fig. 12.
The Start menu shows yo u the different disp lay t ypes:
Set
Check
Menu off
Each d isp lay type in t he Start menu conta ins a subme nu w ith add i-
tional options.
~
Vehicle care Do-it-yourselt service iTechnical data
To Next Page
Loading...
