Audi TT 2010 - Parking Brake

On the road
Parking brake
Parking brake
When the parking brake is set, it prevents the vehicle
from rolling away unintentionally.
Setting the parking brake
Fig. 79 Ce nte r
conso le: Parking brake
set
- Pull the parking brake lever all t he way up.
Releasing the parking brake
- Pull the parking brake lever up slightly and press the
release button at the same time::::::, fig. 79 -arrow-.
- Keep t he release button pressed and lower t he parking
brake::::::,& .
If you shou ld drive off wit h the parking bra ke st ill set, a warning t one
will sound and the following will appear in the instrument cluste r to
remind you to release t he parking bra ke:
Parking brake set
The parking brake warning comes on only after you have driven for
longer t han 3 seconds and fast er than 5 mph (5 km/h).
The parking brake warning light Brake (USA)/© (CDN) illuminates
when the parking brake is set and you switch on the ignit ion.
& WARNING
Always release the parking brake completely. A partially engaged
brake will overheat the rear brakes, reduce the ir effectiveness and
cause excessive we ar. This could lead to brake failur e and an acci-
dent.
0 Note
Only after the vehicle has come to comp lete stop, should you firmly
set the par king brake and either move t he se lector lever into "P". •
Parking
To prevent a parked vehicle from rolling away, there are
a few things you should do.
When you park your vehicle, do t he following:
- St op t he vehicle using the brake pedal.
- Set t he parking brake firmly.
- Switch off t he engine.
- Move t he selector lever into t he P position::::::,& .
- Remove the ignition key from t he ignit ion lock.
What else you should do when parking your vehicle
on an incline or decline
Turn t he st eer ing wheel so t hat if t he vehicle sho uld st art t o roll, it
will roll into the curb .
I),