Driver information system
Total-trip memory (Trip computer 2)
Unlike the single-trip memory, the total-trip memory is not reset
automatically . This permits you to evaluate your driving data for the
entire period between manual resets.
Fuel range
The estimated cruising range in miles (km) appears in the display. The
display changes in increments of 6 miles (10 km) .
Average fuel mileage
The average fuel economy in MPG (l/100 km) since you last cleared
the memory appears in this display.
Current fuel mileage
The instantaneous fuel consumption in miles per gallon (l/100 km) is
shown in this display. When the vehicle is stationary, the most recent
fue l consumption is disp layed.
Average speed
The average speed in mph (km/h) since the last t ime the d isp lay was
reset appears in the display .
Elapsed time
The length of time that you have been driving since you last reset the
memory appears in this display . The maximum t ime per iod that ca n
be recorded is 999 hours and 59 minutes.
Distance
The elapsed distance since the last time the memory was cleared
appears in the display. The maximum distance that can be recorded is
9,999.9 miles (9,999 .9 kilometers).
[ i J Tips
All stored values will be lost if the vehicle battery is disconnected. •
Operation
The trip computer is controlled by two switches on the
windshield wiper lever.
A
Selecting the trip computer
Fig. 11 Wiper
arm/wiper lever:
controls for the tr ip
computer
- Tap the [Reset) button ® until the trip computer
(memory level 1 or 2) appears in the display=:>
page 21,
fig . 10 .
Selecting the functions
- Push in the upper (lower) protrusion on the function
selector switch @ =:> fig. 11. The functions for the trip
computer are displayed in succession on the respective
memory levels.
Resetting the function to zero
- Push the [Reset) button ® for at least two seconds.
You can reset the following values to zero using the I Reset I button:
• driving time
• distance
• average fuel mileage
• average speed
To Next Page
Loading...
