If the engine contro l unit receives faulty vehicle roadspeed signals,
t he Malfunc t ion Ind icator Ligh t (MIL) will illum inat e. If t his
occu rs, contact the nearest authorized Audi dealer fo r ass istance .
S models
Your vehicle 's top speed is electronica lly limited to 155 mph (250
km/h).
If the eng ine contro l unit receives faulty vehicle roadspeed sig na ls,
the Malfunction Indicator Lamp (MIL)
~
will illum inate . If this
occu rs, contact t he nearest authorized Aud i dealer fo r ass istance .
& WARNING
Always observe the posted speed limits and adjust your speed to
suit prevailing road, traffic and weather conditions. Never drive
your vehicle faster than the maximum speed rating of the tires
installed . •
Controls and equip-
ment
Safety first
Driver information system
Trip computer
Introduction
The trip computer gives you information on current and
average fuel m ileage, average speed, fuel range and
driving time .
Fig. 10 Trip computer
1
You can switch between the trip computer 1 and 2 by press ing the
I Reset) bu t ton @ ::;, page 22, fig . 11.
You can tell w hich memory level is currently ac t ive by the number in
the d isp lay ::;, fig. 10 . The data from the sing le-trip memo ry (memory
level 1) is being disp laye d if a
1 appea rs in t he display. If a 2 is show n,
then the data from the total-trip memory is be ing d isplayed (memory
level 2).
Single-trip memory (Trip computer 1)
The sing le-t rip memory sto res t he tr ip information from the t ime the
ignition is turned on unti l it is t urned off. If the trip is contin ued
within 2 hours from t he t ime t he igni ti on wa s t urned off, t he new
data will be included in the ca lculat ion of the current tr ip informa-
t ion.
If t he t rip is interrupted for more than 2 hours the memo ry is
reset automatically . ..,_
Vehicle care Technical data
To Next Page
Loading...
