Audi TT 2012 - Page 34

32 Driver information system
Speed warning l: setting a speed limit
Warning threshold 1 is set by the button .
Fig. 24 Sect ion of instr ume nt cluste r: Set/Check but·
ton
Storing the maximum speed
.. Drive at the desired maximum speed.
.. Press the knob button c:> fig. 24 until the
speed warning symbol
[i (USA models)![i
(Canada models) appears .
Resetting the maximum speed
.. Drive the vehicle at a speed of at least
3 mph (5 km/h)
.. Press the knob for more than 2 seconds.
The speed warn ing symbo l
[81 (USA models)/
Hll (Canada models) will appear briefly in the
display when you release the button to ind i·
cate that the maximum speed has been stored
successfully.
The maximum speed remains stored until it is
changed by pressing the button again briefly
or until it is deleted by a lengthy push on the
button .
Speed warning 2: setting a speed limit
Switches in the wiper arm are used to operate
warning threshold
2.
'--- @
Fig. 25 Wiper lever: Trip computer contro ls
To store maximum speed
.. Turn off the ignition .
.. Briefly press the button in the instrum ent
cluster c:> page 32, fig. 24 . The odometer
and the dig ital clock are now ill uminated .
.,
u,
8
,;.
~
.. Press the button for at least 2 seconds. The
current ly stored maximum speed appears in
the display
or the crossed out symbol for
warning thresho ld 2, if no maximum speed
was set previously .
.. Press the function selector switch in the
w iper lever @ c:> fig . 25 up or down to
change the set value. Values run up or down
in steps of 6.2 mph (10 km/h) .
To delete maximum speed
.. Turn off the ignition .
.. Briefly press the button in the instrume nt
cluster c:> page 32, fig . 24 . The odometer
and the digital clock are now illuminated .
.. Press the button for at least 2 seconds. The
current ly stored maximum speed appears in
the display .
.. Press the reset button in the wiper lever @
c:> fig. 25 until the crossed out speed warn-
ing symbol for warning threshold 2 appears
in the display.
A few seconds after the adjustment is com-
pleted, the illumination for the odometer and
the digital clock will go out. ..,.