92 Hom e lin k®
may not be sufficient for the Homelink ® sys-
tem to learn the radio frequency signal. Per-
form all other steps as described above .
Operating the Homelink ® transmitter
The HomeLink® transmitter works in the
some manner as the original hondheld re-
mote control that come with the system.
Fig. 97 Overhead console: Home lin k® keypad
.,. Press the appropriate programmed button
(D, ® or @) to activate the des ired remote
control funct ion
c::> &, in General informa-
tion on page 90.
Reprogramming a single button
A Homelink ® button can be reprogrammed
individually without affecting the other but-
ton allocations.
Programming the overhead keypad
.,. Press the appropriate Homelink ® button
unt il the ind icator light begins flashing
slowly.
Programming the bumper mounted trans
mitter
1. Hold the original remote control at a dis-
tance between
0- 5 in. (0- 13 cm) from the
bumper below the app ropriate head light
fo r your vehicle (use the shortest distance
possib le).
2 . Aim the remote control just below the
driver side head light .
3 . Press and hold the activation button on
the remote control.
4 . The emergency flashers will flash
three
tim es
(afte r about 15- 60 seconds) when
the programming is successful. Now re-
lease the button on the remote control.
.,. If the dev ice utilizes a rolling code, please
follow phase 3 of c::> page 90, Programming
the HomeLink® transmi tter
for rolling code
programm ing .
This procedure will cause the existing pro-
gramming on the Homelink ® button to be
erased!
Erasing the programming of the
Homelink ® transmitter
When you erase the programming , the pro-
gramming on all three of the transmitter
channels with be lost!
.,. Perform steps 1 to 4 as described on
c:::;, page 91, Phase 1: programming the over-
head keypad .
When completed, the Homelink ® system will
be in the prog ramm ing mode and is then
ready to learn the codes fo r remote controlled
devices.
© Tips
- Programmed buttons ca nnot be erased
ind ividually .
- For security reasons you are adv ised to
erase the programming of the Home-
Link® sys t em before you se ll your vehicle .
To Next Page
Loading...
