Audient iD4 - Pro Tools Setup Guide

28
Go to Setup > I/O... to label your inputs
and outputs and ensure that iD4 is correctly
reporting 2-inputs and 2-outputs to and from
Pro Tools.
If using the iD4 Monitor Mix knob to monitor
your inputs, ensure that the input monitor
buttons on the audio tracks are not selected,
to avoid duplicate signals.
For more Pro Tools information consult your
Avid user manuals & documentation.
Operation with Pro Tools
If using Windows, ensure that you have
followed the installation instructions found on
page 10.
With iD4 connected, launch Pro Tools and
ensure that a new session is created at
the desired sample rate. If you are using
Windows, make sure that you have already
set your Latency and Buer Size settings in
the iD System Tray before opening a project.
Changing these mid session will result in Pro
Tools needing to restart.
Playback Engine
Go to Setup > Playback Engine... and ensure
that iD4 is set as the active playback
device.
Pro Tools Setup