31
Channel Features
Channel Name
By double clicking on the name of the channel
you can rename it to help you organise your iD
mixer application. You could name a channel
‘Kick’ or ‘Snare’ for example.
Phase Flip
Inverts the polarity of the signal by 180° to
stop phase cancellation. This is useful if you
a micing the rear of a guitar amplifier or the
underside of a snare drum.
Pan Control
Allows you to send the audio to the left, to
the right or anywhere between on your Main
Monitor Mix or Cue Mixes.
Stereo Grouping
Allows you to group two adjacent channels
together into a stereo channel with a single
fader controlling the level of both channels.
When a channel is stereo grouped, the pans
will automatically be set to far left and far
right.
Solo
The Solo button mutes all other channels
other than the one that is currently solo’d.
Multiple channels can be solo’d at one time.
Mute
The Mute button stops this channel from
outputting audio whilst it is engaged.
Fader
The fader controls the amount of signal that
is sent to the currently selected mix. This can
be set to anywhere between -inf dB to +6dB.
Meter
The meter shows the current signal level in
dBFS. Should the signal level exceed 0dBFS
then the peak indicators will illuminate red to
indicate a peak. The peak indicators can be
cleared by clicking the mouse cursor in them.
You can also clear all peak indicators using
Alt + Click.
Software Features
To Next Page
Loading...
