24
Line Outputs
iD44 has four line outputs, these can be used
for connecting monitors on the back panel in
the form of balanced TRS jack connectors.
The outputs are impedance balanced using
the same topology as our flagship console,
the
ASP8024-HE.
The outputs are fed from high quality DACs
(Digital to Analogue Converters) sending
clean, linear audio to your speakers, perfect
for critical listening.
You can use these outputs for more than
just speakers. If you want to use hardware
outboard equipment, you can send out up to
four mono, or two stereo signals from these
outputs, this is configured in the iD Software
Mixer.
In order to keep your audio noise free,
we would recommend against the use of
unbalanced (TS, RCA.. etc) cables on the line
outputs.
Headphone Outputs
iD44 features two high current headphone
amplifiers which are fed by separate DACs.
Headphone Output One can be accessed
from both the 3.5mm and 6.35mm sockets
found on the front of the unit. The same
audio signal comes out of both connectors
simultaneously, so it does not matter which
you plug your headphones into. You can also
plug in two pairs at the same time.
Whilst Headphone Output Two can only be
accessed via the 6.35mm output.
These can be used instead of or alongside
speakers to get an idea how your mix
translates to headphones, or to provide artist
headphone mixes
The headphone outputs can comfortably
drive a wide range of headphone impedances
meaning that you will get great sounding
audio no matter what model of headphones
you have.
To Next Page
Loading...
