Audient iD44 - Page 36

36
System Panel Features
Digital I/O Format
Allows you to select whether each optical
input or output uses ADAT or
S/PDIF digital format.
Preferred Clock Source
The Clock source can be selected from either
the internal clock or one of the two optical
inputs. More information about choosing a
clock source can be found in the clocking
section of this manual.
When using an external clock source the
indicator beside the selector shows the
current status of the clock on that input.
• Red - No clock signal detected on input
• Amber - A clock signal is detected but at
a dierent sample rate to iD44
• Green - A clock signal is detected and is
at the correct sample rate.
For an external clock source to be working
correctly you would want the indicator to
be green. If the indicator isn’t green, iD44
will default back to the internal clock until it
detects a valid clock input.
Mono Mode
When the iD44’s Mono feature is engaged
this option controls whether the mono signal
is sent to the left, right or both monitors.
Dim Level
When the iD44’s dim button is pressed, this
control defines how much the level is reduced
by.
ALT Speaker Level
This control defines the level drop/boost
when the iD44 is switched to ALT speaker
mode. This is used to balance levels between
dierent speaker brands or types.
Output Routing Selection
Opens the routing matrix for either the
Analogue Outputs, Digital Output 1, Digital
Output 2 or the Talkback channel.