Audio Technica AT-LP3 User Manual

15
Specifications
Turntable specifications
Type 2-Speed, fully automatic operation
Motor DC motor
Drive method Belt drive
Speeds 33-1/3 RPM, 45 RPM
Turntable platter Die-cast aluminium
Wow and flutter < 0.2 % WRMS (33 RPM) at 3 kHz
Signal-to-noise ratio > 60 dB
Outputs levels
“PHONO”
“LINE (MM)”
3.5 mV nominal at 1 kHz, 5 cm/sec
220 mV nominal at 1 kHz, 5 cm/sec
Phono Pre-amp gain (MM)
Phono Pre-amp gain (MC)
36 dB nominal, RIAA equalized
56 dB nominal, RIAA equalized
Tonearm specifications
Type Static balanced straight shaped w/soft
damping control
Effective length 221.5 mm
Overhang 19 mm
Maximum tracking error angle Less than 3°
Stylus pressure adjustment range 1 to 4 g
Applicable cartridge weight range
(including headshell)
14.5 to 20 g
Cartridge and headshell specifications
Cartridge Model AT91R
Cartridge Type VM Dual Magnet
Recommended load impedance 47,000 ohms
Output voltage 3.5 mV (mV at 1 kHz, 5 cm/sec)
Stylus 0.6 mil bonded conical
Cantilever Aluminum pipe
Tracking force range 1.5 to 2.5 g (standard 2.0 g)
Cartridge weight 5.0 g
Headshell model AT-HS3
Headshell weight 11.1 g
Headshell overhang adjustment 8 mm
General specifications
Power supply requirements 120 V / 60 Hz
Power consumption 2 W
Dimensions 435 mm (17.13")×353 mm (13.90")×
128 mm (5.04")
(W×D×H)
Weight 5.4 kg (11.91 lbs)
Accessories included Rubber mat, Dust cover, Platter (with
drive belt), Counterweight, Headshell
(AT-HS3) with VM stereo cartridge
(AT91R), 45 RPM adapter, Power cable
Replacement stylus (sold
separately)
ATN91R
Replacement headshell (sold
separately)
AT-HS3
Replacement belt (sold separately) AT-LP3 exclusive belt
Specifications are subject to change without notice due to improvements.
AT-LP3_UM_V2_ATUS_book.indb 15 2016/11/29 11:17

Audio Technica AT-LP3 Specifications

General

Type	Belt-drive audio turntable
Operation	Fully automatic
Motor type	DC motor
Output level	220 mV
Product color	White
Wow & flutter	0.2 %
Output voltage	3.5 mV
Platter material	Aluminum
Turntable speeds	33 1/3, 45 RPM
Signal-to-Noise Ratio (SNR)	60 dB
Overhang	19 mm
Tonearm type	Statically balanced tonearm
Tracking angle	3 °
Tracking force range	1.5 - 2.5 g
USB ports quantity	0
Quantity	1
Counterweight	Yes
Cables included	AC
AC adapter frequency	50/60 Hz
AC adapter input voltage	220 - 240 V
Power consumption (typical)	2 W
Package depth	480 mm
Package width	520 mm
Package weight	6900 g

Weight and Dimensions

Depth	353 mm
Width	435 mm
Height	128 mm
Weight	5200 g